Certified VoIP Secure Entry & PA - Global Shipping


  • cisco pass through poe
  • cisco poe switch spec

2 Port Pass Through PoE & GIG Switch – Turns 1 PoE Port into 2 – No Mains Power Required

The CyberData Pass through PoE Switch expands one PoE Port into two. The switch requires no mains power.

SKU: 011187 Category:
  • Description

Product Description

The Pass through PoE switch is powered from a single 802.3at or 802.3af network switch and passes that power through to one or two of the downstream switch ports.

An installation example would be

Lets say you was installing an IP camera and an IP Intercom. However, you only had one PoE network point to utilize. Rather than making a cable run, you can use the Pass through POE switch. it takes the single PoE port and turns it into two.

No mains power is required


  • 2-Port auto-negotiating (no crossover cable required)
  • 10.100.1000 full duplex (PoE-powered)
  • Link/Status and connection speed LEDs
  • VLAN Packet Forwarding
  • 9216-byte jumbo packet length forwarding at wire speed
  • RoHS compliant
  • Supports PoE IEEE802.3at compliant
  • Supports PoE IEEE802.3af compliant
  • Support two power source equipment to supply external devices
  • Supports IEEE802.3x flow control for full-duplex mode and back pressure for half-duplex mode
  • Support ports Auto MDI/MDIX
  • 8K entry MAC address table of the switch with auto-learning and auto-aging
  • LED indicators for monitoring PD, PSE, Link / Activity
  • No external power supply design

Data Sheet PDF

You may also like…